Find Locations
For hours, walk-ins and appointments.Unable to load global navigation.
Find Locations
For hours, walk-ins and appointments.If the patient's hematocrit exceeds 55%, the volume of citrate in the collection tube must be adjusted. Refer to Coagulation Collection Procedures for directions.
2 - 3 days
Turnaround time is defined as the usual number of days from the date of pickup of a specimen for testing to when the result is released to the ordering provider. In some cases, additional time should be allowed for additional confirmatory or additional reflex tests. Testing schedules may vary.
For more information, please view the literature below.
Procedures for Hemostasis and Thrombosis: A Clinical Test Compendium
Plasma, frozen
1 mL
Blue-top (sodium citrate) tube
Blood should be collected in a blue-top tube containing 3.2% buffered sodium citrate.1 Evacuated collection tubes must be filled to completion to ensure a proper blood-to-anticoagulant ratio.2,3 The sample should be mixed immediately by gentle inversion at least six times to ensure adequate mixing of the anticoagulant with the blood. A discard tube is not required prior to collection of coagulation samples unless the sample is collected using a winged (butterfly) collection system. With a winged blood collection set a discard tube should be drawn first to account for the dead space of the tubing and prevent under-filling of the evacuated tube.4,5 When noncitrate tubes are collected for other tests, collect sterile and nonadditive (red-top) tubes prior to citrate (blue-top) tubes. Any tube containing an alternative anticoagulant should be collected after the blue-top tube. Gel-barrier tubes and serum tubes with clot initiators should also be collected after the citrate tubes.
Please print and use the Volume Guide for Coagulation Testing to ensure proper draw volume.
Freeze.
Temperature | Period |
---|---|
Frozen | 28 days |
Freeze/thaw cycles | Stable x3 |
Ideally the patient should not be on anticoagulant therapy. Avoid warfarin (Coumadin®) therapy for two weeks prior to the test and heparin, direct Xa, and thrombin inhibitor therapies for about three days prior to testing. Do not draw from an arm with a heparin lock or heparinized catheter.
Severe hemolysis; improper labeling; clotted specimen; specimen diluted with IV fluids; samples thawed in transit; improper sample type; sample out of stability
This test is used to evaluate an isolated prolonged PT or for evaluation when both the aPTT and PT are prolonged and to assess factor V activity level.6-8
This test is not used for the diagnosis of factor V Leiden mutation. Direct Xa or thrombin inhibitor therapy may cause factitiously low results.
Factor V activity is determined utilizing a prothrombin time (PT)-based one-stage clotting time assay. Factor V-depleted plasma is used as the substrate, and the clotting time with the patient plasma is compared to the clotting time of normal pooled plasma.
Factor V is a large (330 kilodalton) single-chain nonenzymatic cofactor that is synthesized in hepatocytes, megakaryocytes, and endothelial cells.6,7,9 Approximately 20% of the total factor V is carried in the α granules of platelets and is released when platelets are activated.6 The structure of factor V is similar to that of factor VIII.9 Factor V's plasma concentration is 7 mg/mL and half-life is about 15 to 36 hours. Factor V activation occurs by both the extrinsic and intrinsic pathways. Factor V deficiency should be considered when a patient with bleeding history has both extended protime (PT) and activated partial thromboplastin time (aPTT).
Congenital factor V deficiency, sometimes referred to as parahemophilia, is rare (less than one case per million individuals) and is inherited as an autosomal recessive trait.6,7,9 This condition affects both males and females and the prevalence of inherited factor V deficiency is equal in all ethnic groups.9 Factor V levels are decreased both in plasma and platelets.6 A syndrome of combined factor V and VIII deficiencies has been described in over 60 families in and around the Mediterranean basin.8
Symptoms (homozygotes) can include hematoma formation, postsurgical and postpartum hemorrhage, menorrhagia, hematuria, and umbilical cord hemorrhage.6,9 Factor V plasma activity <30% may result in excessive bleeding following a traumatic event.9 Unlike individuals with severe hemophilia, patients with factor V levels <1% do not typically develop spontaneous joint hemarthroses.6
Diminished factor V levels can be seen in liver disease, disseminated intravascular coagulation (DIC) syndromes, and in other consumption coagulopathies.9,10 Specific factor V inhibitors can occur, especially after surgical procedures that involve multiple exposures to bovine topical thrombin.9 Postoperative treatment with aminoglycosides and penicillin has also been associated with development of factor V inhibitors.6,7 Inhibitors do not typically develop in individuals with factor V deficiency.6 One study found that elevated factor V activity may be associated with increased risk for myocardial infarction;11 however, a recent consensus conference of the College of American Pathologists on diagnostic issues in thrombophilia did not recommend measurement of factor V levels for the assessment of thrombotic risk.10
Order Code | Order Code Name | Order Loinc | Result Code | Result Code Name | UofM | Result LOINC |
---|---|---|---|---|---|---|
086249 | Factor V Activity | 3193-0 | 086249 | Factor V Activity | % | 3193-0 |
© 2021 Laboratory Corporation of America® Holdings and Lexi-Comp Inc. All Rights Reserved.
CPT Statement/Profile Statement
The LOINC® codes are copyright © 1994-2021, Regenstrief Institute, Inc. and the Logical Observation Identifiers Names and Codes (LOINC) Committee. Permission is granted in perpetuity, without payment of license fees or royalties, to use, copy, or distribute the LOINC® codes for any commercial or non-commercial purpose, subject to the terms under the license agreement found at https://loinc.org/license/. Additional information regarding LOINC® codes can be found at LOINC.org, including the LOINC Manual, which can be downloaded at LOINC.org/downloads/files/LOINCManual.pdf